We have several plinths that have been in storage for some time.

Whilst they not be perfect, this mainly affects the internal cutouts and will not affect the final appearance of the finished assembly.

They will be sold as unfinished examples for the customer to complete and as a bare plinth only with no accessories.

This involves the final honing and oiling and is not difficult for the DIYer.

Full advice will be offered and no specialist tooling will be required.

301 Top layer of a twin plinth in 20mm, perfect just needs final polishing and oiling......£300

301 20mm single layer with round armboard cut out (no armboard inc)
An early piece with with a slightly rough center cut out (not visible when assembled) £200 TBH the cut out is not that rough but it wasn't cut with a waterjet.

401 20mm, as above with no arm hole, i.e. blank ready to be drilled for armboard of your choice. £200 Now sold

401 round armboard cutout (no armboard inc) in a non standard 36mm thickness and oversize plinth at 505W x 450D
i.e. much heavier than a standard plinth, This is waterjet cut and perfect.
£450

These are limited to just a few items and we would not expect them to to be around for long.

(All and any offers are not applicable to any Ebay auction sales)

Contact Slatedeck

HOME